Builders & Developers
A 40-lot townhouse release does not want 40 kitchens landing on one day. Cabinetry is produced and labelled to the order you call off, so lots can be released as slabs are poured and frames are closed.
Trade channels
Trade & partner supply
Four routes into the same workshop. Choose the one that matches how you buy, and the page sets out what we need from you, what you get back, and which terms are still open.
Choose your route
Architects & Designers
Design intent usually survives the drawing stage and dies at the millimetre. Our job is to tell you early which junctions need a decision, what the minimum reveal is on the profile you have chosen, and where a nominated material will fight the detail.
Dealers & Importers
An importer's margin lives in cubic metres, not in door profiles. We publish packing plans and load calculations against your container type, so the quote you receive reflects what actually fits.
Order Process
This page exists because most disputes about imported cabinetry are not about quality — they are about expectations that were never written down. So we write them down, stage by stage.
Stated up front
Where our scope ends
The earlier we are clear about what we do not do, the cheaper the project is for everyone.
What we do not do
- We do not provide design services; design decisions stay with you.
- We do not install, and we do not subcontract installation in Australia.
- We do not attend site to measure.
- We do not supply appliances, stone benchtops, plumbing or electrical work.